Black BLK-PTZ12X Installationsanleitung PDF herunterladen (Seite 99)

User Manual

 Upload Image by E-Mail

Select this item and the Administrator can assign an e-mail address

and configure various parameters as shown in the figure below. When

motion is detected, event images will be sent to the appointed e-mail

address.

Pre-trigger buffer> function allows users to check what happened to

cause the trigger. The <Pre-trigger buffer> frame rate could be

pre-determined.

On the other hand, <Post-trigger buffer> is for users to upload certain

amount of images after the motion event occurs.

Check the box <Continue image upload> to upload the triggered

images during certain time or keep uploading until the trigger is off.

Select <Upload for __sec> and enter the duration in the blank. The

images of the duration will be uploading by E-mail when the motion

event occurs. The setting range is from 1 to 9999 seconds. Select

<Upload during the trigger active> to make the images keep being

uploaded to E-mail during the trigger active until the event stops. Set

the Image frequency as the upload frame rate. The setting range is

from 1 frame to 15 frames.

NOTE: Make sure SMTP configuration has been completed.

Refer to 5.3.5 Mail for further details.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 164 165

Keine Kommentare

Black BLK-PTZ12X Installationsanleitung Seite 99