Black BLK-PTZ12X Installationsanleitung PDF herunterladen (Seite 98)

User Manual

 Send Alarm Message by FTP/E-Mail

The Administrator can select whether to send an alarm message by

FTP and/or E-Mail when motion is detected.

 Upload image by FTP

Select this item and the Administrator can assign a FTP site and

configure various parameters as shown in the figure below. When

motion is detected, event images will be uploaded to the appointed

FTP site.

<Pre-trigger buffer> function allows users to check what happened to

cause the trigger. The <Pre-trigger buffer> frame rate could be

pre-determined.

On the other hand, <Post-trigger buffer> is for users to upload certain

amount of images after motion event occurs.

Check the box <Continue image upload> to upload the triggered

images during certain time or keep uploading until the trigger is off.

Select <Upload for __sec> and enter the duration in the blank. The

images of the duration will be uploaded to FTP when the motion event

occurs. The setting range is from 1 to 9999 seconds. Select <Upload

during the trigger active> to make the images keep being uploaded to

FTP during the trigger active until the event stops. Set the Image

frequency as the upload frame rate. The setting range is from 1 frame

to 15 frames.

NOTE: Make sure FTP configuration has been completed.

Refer to 5.3.6 FTP for further details.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 164 165

Keine Kommentare

Black BLK-PTZ12X Installationsanleitung Seite 98