Black BLK-PTZ12X Installationsanleitung PDF herunterladen (Seite 89)

User Manual

 Enable Alarm Output

Select the item to enable alarm relay output.

 Send Alarm Message by FTP/E-Mail

The Administrator can select whether to send an alarm message by

FTP and/or E-Mail when an alarm is triggered.

 Upload Image by FTP

Select this item and the Administrator can assign a FTP site and

configure various parameters as shown in the figure below. When the

alarm is triggered, event images will be uploaded to the appointed FTP

site.

<Pre-trigger buffer> function allows users to check what happened to

cause the trigger. The <Pre-trigger buffer> frame rate could be

pre-determined.

On the other hand, <Post-trigger buffer> is for users to upload certain

amount of images after the alarm input is triggered.

Check the box <Continue image upload> to upload the triggered

images during certain time or keep uploading until the trigger is off.

Select <Upload for __sec> and enter the duration in the blank. The

images of the duration will be uploaded to FTP when the alarm input is

triggered. The setting range is from 1 to 9999 seconds. Select <Upload

during the trigger active> to make the images keep being uploaded to

FTP during the trigger active until the alarm is released. Set the Image

frequency as the upload frame rate. The setting range is from 1 frame

to 15 frames.

NOTE: Make sure FTP configuration has been completed.

Refer to FTP for further details.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 164 165

Keine Kommentare

Black BLK-PTZ12X Installationsanleitung Seite 89