Black BLK-IPS103 Bedienungsanleitung PDF herunterladen (Seite 13)

11H.264 Network IP Camera User Manual

SECTION 2: INSTALLATION AND SETUP

The IPAdminTool can be loaded on a Microsoft Windows XP, Vista or Windows 7 operating system (32- or 64-bit). To use this utility

for the initial setup of your camera, your computer must be connected to the same network subnet as your camera.

At a computer on the same LAN (subnet) where your cameras will be installed, do the following:

1. Insert the CD mini disk provided with your camera into your computer’s CD ROM drive and open the CD in a Windows

Explorer window.

2. Find the IPAdminTool directory on the CD.

3. Copy the IPAdminTool directory with its contents to your computer hard drive.

2.6 Congure the camera network settings

Devices attached to a Local Area Network (LAN) are each assigned a unique address (IP address) that they use when sending

messages with each other. No two devices on a single Ethernet network can have the same IP address. Otherwise, addressing

conicts will occur.

When your IP camera is attached to a network and initially powered on, it attempts acquire compatible network settings from

a DHCP server. If it cannot nd a DHCP server, it congures itself with the following static IP address, subnet mask, and gateway

setting, which may or may not be compatible with other devices on the network.

IP address: 192.168.0.100

Subnet mask: 255.255.255.0

Gateway: 192.168.0.1

Whether it acquires a dynamic (changeable) IP address and other network settings from a DHCP server, or uses the default static

(xed, unchanging) settings, your camera must be congured with static network settings that are compatible with the network

conguration. Additionally, if DHCP is not used on your network, DIGIOP Black cameras must be installed on the network and

congured with new network settings one at a time to avoid addressing conicts.

Use the following procedure to setup and apply compatible, static, network settings for your camera. If connecting your camera to a

large enterprise network, consult with your network administrator for network settings before attaching the camera to the LAN to

ensure that your camera won’t conict with other devices. Your network administrator should also setup WAN (Internet) access to

the camera, if that is needed.

If you encounter a problem and need to contact Technical Support, rst complete the chart in Table 1 about your computer (PC) and

camera network settings, if possible. Support will need this information to provide assistance.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Keine Kommentare

Black BLK-IPS103 Bedienungsanleitung Seite 13