Black BLK-CPT235VH2 Bedienungsanleitung PDF herunterladen (Seite 10)

www.digiop.com

SECTION 2: INSTALLATION

5. While observing video from the camera, loosen the bracket base adjustment lock nut and the bracket adjust hex screws.

6. Point the camera at your surveillance target, then tighten the bracket ring and hex screws to lock the bracket in place.

360°

180°

360°

Bracket Adjustment

Lock Nut

Bracket Adjust

Hex Screws

Tele-Wide

Adjustment

Near-Far

Adjustment

OSD Controls

(under cover)

7. Rotate the Far - Near adjustment ring and the Tele - Wide adjustment ring to improve the image of the your

surveillance target.

8. Congure your camera using the software menus in the OSD. See Software Setup in the following section of this

manual.

2.3.1 LED LEVEL adjustment

The LED LEVEL is preset at the factory. However, an adjustment screw is provided on the OSD panel of the BLK-CPT237VH2, BLK-

CZT242VH2 and BLK-CZT243VH cameras for environments where the image brightness in dark conditions is still not satisfactory

after performing a Software Setup of the camera. The LED LEVEL for the BLK-CPT235VH camera is not adjustable.

To adjust the LED LEVEL of a BLK-CPT237VH2, BLK-CZT242VH2 or BLK-CZT243VH camera:

1. WIth the camera operating in a dark environment, unscrew the OSD panel access cover to access the OSD controls.

2. While observing the video image from the camera, use a screwdriver to turn the LED LEVEL screw to counter-clockwise to

brighten the image, and/or clockwise to darken the image until the image brightness is acceptable.

3. Reinstall the OSD panel access cover.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Keine Kommentare

Black BLK-CPT235VH2 Bedienungsanleitung Seite 10